Any Miles From Columbus, OH

Customize your Search Radius & Location

Automobiles616

More Links

Hire It HauledFree / Giveaway ItemsPet GiveawaysWant AdsTradingStores & Dealers

My Links

Saved Searches0 Watch List0 Recently Viewed0

Mechanical Part

607 Results
DOHCTER
2023-12-16 20:52:52
Used fluidyne honda half radiator with electric fans.
Lincoln, ND
$120
BKH
2023-12-16 07:14:24
3 Photos
New in the box connecting rods. These are Maxspeeding performance rods. They come
with Arp bolts and pin bushings. They are roughly a 18mm pin and 40mm bottom. Bought for a project that did not get
New England, ND
$250
BKH
2023-12-16 07:14:36
2 Photos
MASTER CYLINDER FOR A LATE 70'S DATSUN PICKUP.
New England, ND
Make an Offer
BKH
2023-12-16 07:14:35
Custom made headers for a 60 series Ford flat head V8.
The pipes can be shortened, they were for another project that they did not get used on.
New England, ND
$200
BKH
2023-12-16 07:14:27
Honda remaned engine...ready to install!!!
Early 80's Honda engine.It is a completely remaned.Engine has all new internal parts.It also has a new cylinder head.Its complete with everything on it.Also have the clutch,alternator,starter, and
New England, ND
$750
Tom
2023-12-12 15:57:05
Multiple Like New Allison Transmissions
Like new internals. Pics of each. Cash or trades. Willing to work deals. 5 and 6 speeds available. Pm me with any questions. Thnx
Harrisburg, SD
Make an Offer
nddl
2023-12-11 14:01:10
3 Photos
GM 2.5 new Badger piston 4 cyl
I have a new set of piston for a gm 2.5 engine for sale these are badger pistons and are marked .30
Bismarck, ND
$80  OBO
Floyd Roll
2023-12-10 18:18:45
3 Photos
FORD FE Factory 3 Deuce | Intake and Carburetor Assembly OEM 406 427 428 390 CID
Minot, ND
$3,000
Blaine
2023-12-10 11:27:31
3 Photos
New fuel pump for a 1995 pontiac sunfire 4 door.
Bismarck, ND
$75
Mark
2023-12-09 14:03:24
Selling a front tie rod center link for 70-81 Camaros
Brand new never installed Paid $60, Asking $50 Located in Glyndon mn Message with any ???s
Glyndon, MN
$50
Mark
2023-12-09 13:52:36
2 Photos
Selling a brand new set a Taylor 8.2mm spark plug wires for gm v8s
Located in Glyndon mn Asking $100 Message me with any???s thanks
Glyndon, MN
$100
wolf912
2023-12-07 11:06:55
4 Photos
Fantech FKD 16"with ec motor inline fan. This fan has very low hrs on it
(probably less than 150) and is designed for commercial 24/7 operation with lifespan up to 10 years continuous use. The speed
Bismarck, ND
$1,500  OBO
Brian
2023-12-04 06:43:33
3 Photos
2006 BMW X3 3.0i Used Engine Assembly
We have for sale a used Engine Assembly out of a 2006 BMW X3, will fit 2004 - 2006 X3 model years. Runs great Sounds great, does not smoke or knock,
Inkster, ND
$1,000  OBO
Dylan
2023-12-03 17:27:03
2017-2019 GM HD Truck Cognito Front drive shaft.
Eliminates the vibration when vehicle is lifted. Sold truck, no longer need. About 3k miles.
Bismarck, ND
$350  OBO
Mark
2023-11-30 17:34:52
2 Photos
2015-2022 OEM Mustang EcoBoost Catback Exhaust
Selling a dual-tip catback exhaust pulled from a 2022 Mustang EcoBoost. Was pulled from the vehicle at arpund 2,000 miles. Minimal rust, no structural
Fargo, ND
$375  OBO
Brian
2023-11-29 09:00:52
2 Photos
2004 - 2010 BMW X3 3.0i FRONT TIE ROD ASSEMBLY LEFT OR RIGHT SIDE (NEW)
This is a NEW aftermarket inner and outer tie rod assembly ordered for a 2006 BMW X3 never opened still in original packaging
Inkster, ND
$75  OBO
moparfan1
2023-11-28 19:18:03
6.7 Cummins 2nd gen swap kit
Seeing if there's any interest in my 2nd Gen kit. Low low miles on it, 15k miles. Specs are the turbo is a Borgwarner S467.7 FMW turbo with a Steed Speed manifold, Fleece
Wildrose, ND
Make an Offer
little j
2023-11-27 12:49:23
5 Photos
Sbc heads (2) sets one is 991 an not sure on the others
$200 ($100 each set)
Minot, ND
$200  OBO
Mark
2023-11-26 14:40:54
Paying cash for Holley 4412-S 2 BBL carbs. Un altered only ..
Bismarck, ND
HKT Big Sky Motors
2023-11-20 13:13:17
New Automatic Transmission Control Valve Body with TCM General Motors #24041728
#240141956 Assembly. Incl.Control Module. This part requires programming and/or special setup procedures GM Service
Glendive, MT
$495
Sam
2023-11-19 11:13:48
Turbo
Dickinson, ND
$200
Casey
2023-11-18 08:41:03
3 Photos
73 chevy impala new gas tank and sender.
Less then 10 gallons ran though it. Cash only.
Hazen, ND
$225
Casey
2023-11-18 08:40:40
3 Photos
1990 K1500 Front Drive Shaft Chevy GM
Used drive shaft from 1990 Chevy K1500 with 700r4 and 241 C transfer case. Splines have some play but not bad. U-joints feel good. Cash only located in
Hazen, ND
$100
Tom
2023-11-17 12:09:06
Allison 1000 transmissions!
Refurbished Allison Transmissions! Plenty of options can rebuild your 5-6 speed also Open to offers. Can send pics. Just let me know whats needed. Thnx
Harrisburg, SD
Contact for Price
Mark
2023-11-15 21:09:07
Paying cash for rebuildable 350 chevrolet engines. Preferred 67 to 77 pickup engin
es, factory 4 bolt mains.
Bismarck, ND
krew
2023-11-14 17:22:14
2 Photos
fan shroud v6 90 chevy.
brand new 1990 K1500 chevy fan shroud.
Mandan, ND
$55
Jeff
2023-11-13 00:35:17
3 Photos
DANA 44 GEAR SET 4.10 GEAR RATIO
In very nice condition. From the front of a 70's Chevy 4X4, Will fit most any Dana 44 axle that has the fine spline yoke.
Hazen, ND
$50
Mark
2023-11-10 22:39:24
Looking for good running BB Chevy engine. No tall block or industrial motors pleas
e. Paying cash. 402 396 454 427 ect.
Bismarck, ND
Mark
2023-11-10 22:37:36
Looking for part number 4412-S holly 2bbl carbs Paying cash
Bismarck, ND
Brian
2023-11-06 09:10:05
4 Photos
3.9L,General Motors SFI, V6, Used Engine Assembly
We have For Sale a 3.9 L V6 engine out of a 2008 Chevrolet Uplander, with a Engine VIN code of 1 and build sheet code of LZ9. Will work in other
Inkster, ND
$1,000
607 Ads | Page 19 of 21 | Jump to Page: