Any Miles From Columbus, OH

Customize your Search Radius & Location

Automobiles613

More Links

Hire It HauledFree / Giveaway ItemsPet GiveawaysWant AdsTradingStores & Dealers

My Links

Saved Searches0 Watch List0 Recently Viewed0

Mechanical Part

606 Results
Brian
2023-11-29 09:00:52
2 Photos
2004 - 2010 BMW X3 3.0i FRONT TIE ROD ASSEMBLY LEFT OR RIGHT SIDE (NEW)
This is a NEW aftermarket inner and outer tie rod assembly ordered for a 2006 BMW X3 never opened still in original packaging
Inkster, ND
$75  OBO
moparfan1
2023-11-28 19:18:03
6.7 Cummins 2nd gen swap kit
Seeing if there's any interest in my 2nd Gen kit. Low low miles on it, 15k miles. Specs are the turbo is a Borgwarner S467.7 FMW turbo with a Steed Speed manifold, Fleece
Wildrose, ND
Make an Offer
little j
2023-11-27 12:58:14
4 Photos
Sbc mini starter used
Asking $140 obo Make me an offer
Minot, ND
$140  OBO
little j
2023-11-27 12:52:57
5 Photos
Sbc
Oil pan ($50) (2) timing chain covers ($20 each) Tall boy valve covers green($100) Make me an offer
Minot, ND
$190  OBO
little j
2023-11-27 12:49:23
5 Photos
Sbc heads (2) sets one is 991 an not sure on the others
$200 ($100 each set)
Minot, ND
$200  OBO
little j
2023-11-27 12:46:57
5 Photos
(2) 2 barrel 2 jet Rochester carburetors
$100 ($50 each)
Minot, ND
$100  OBO
little j
2023-11-27 12:43:42
10 Photos
Ford 9” rear gears 5:83 aluminum full spool
5:67 ring an pinion new in box never used (2) mini spool hubs 1 have 28 spline mini spool an one has nothing asking $500 obo
Minot, ND
$500  OBO
Mark
2023-11-26 14:40:54
Paying cash for Holley 4412-S 2 BBL carbs. Un altered only ..
Bismarck, ND
HKT Big Sky Motors
2023-11-20 13:13:17
New Automatic Transmission Control Valve Body with TCM General Motors #24041728
#240141956 Assembly. Incl.Control Module. This part requires programming and/or special setup procedures GM Service
Glendive, MT
$495
Sam
2023-11-19 11:13:48
Turbo
Dickinson, ND
$200
Casey
2023-11-18 08:41:03
3 Photos
73 chevy impala new gas tank and sender.
Less then 10 gallons ran though it. Cash only.
Hazen, ND
$225
Casey
2023-11-18 08:40:40
3 Photos
1990 K1500 Front Drive Shaft Chevy GM
Used drive shaft from 1990 Chevy K1500 with 700r4 and 241 C transfer case. Splines have some play but not bad. U-joints feel good. Cash only located in
Hazen, ND
$100
Tom
2023-11-17 12:09:06
Allison 1000 transmissions!
Refurbished Allison Transmissions! Plenty of options can rebuild your 5-6 speed also Open to offers. Can send pics. Just let me know whats needed. Thnx
Harrisburg, SD
Contact for Price
Mark
2023-11-15 21:09:07
Paying cash for rebuildable 350 chevrolet engines. Preferred 67 to 77 pickup engin
es, factory 4 bolt mains.
Bismarck, ND
krew
2023-11-14 17:22:14
2 Photos
fan shroud v6 90 chevy.
brand new 1990 K1500 chevy fan shroud.
Mandan, ND
$55
enminot
2023-11-13 00:36:53
3 Photos
Sound Performance T4 Quick Spool Valve
Sound Performance/SP Quick Spool Valve for a T4 twin scroll turbo. This was paired with a TC78 turbo as a rear mount setup on my '97 Camaro. It's been on my shelf since I switched to a front mount
Minot, ND
$350
Jeff
2023-11-13 00:35:17
3 Photos
DANA 44 GEAR SET 4.10 GEAR RATIO
In very nice condition. From the front of a 70's Chevy 4X4, Will fit most any Dana 44 axle that has the fine spline yoke.
Hazen, ND
$50
Mark
2023-11-10 22:39:24
Looking for good running BB Chevy engine. No tall block or industrial motors pleas
e. Paying cash. 402 396 454 427 ect.
Bismarck, ND
Mark
2023-11-10 22:37:36
Looking for part number 4412-S holly 2bbl carbs Paying cash
Bismarck, ND
Cody M
2023-11-08 07:09:41
3 Photos
2006 Toyota Rav 4 water pump. No issues, just replaced while doing other engine wo
rk. Make an offer.
Bismarck, ND
Make an Offer
Brian
2023-11-06 09:10:05
4 Photos
3.9L,General Motors SFI, V6, Used Engine Assembly
We have For Sale a 3.9 L V6 engine out of a 2008 Chevrolet Uplander, with a Engine VIN code of 1 and build sheet code of LZ9. Will work in other
Inkster, ND
$1,000
Jeff k
2023-11-03 13:20:57
3 Photos
Alternator new in box 2014 duramax
250$. Will fit other years as well
Sawyer, ND
Make an Offer
gator
2023-10-27 20:37:19
2008 dodge 6.7 Cummins EGR parts.
They have around 70,000 miles on them. No issues when removed. What you see is what you get. EGR cooler, bracket, valve exhaust adapter, clamps, hardware, bypass
Medina, ND
$800  OBO
Caleb
2023-10-25 21:43:37
HSP cold air intake
Decided to do a different color. Still in the box has never been installed intake is for 2013-2016 LML Color is White Shoot me a text if you have any questions. I dont always answer the
Ray, ND
$400  OBO
DW drum lover
2023-10-24 09:14:43
3 Photos
Willwood adjustable proportioning valve.
Brand new willwood adjustable brake propositioning valve. Brand new never opened out of the package. Don’t need it anymore. $40
Minot, ND
$40
Lightning_3383
2023-10-24 00:47:45
3 Photos
Parting out 1999 Chevy Tahoe
I bought it for parts, engine is bad. It is a Vortec 5.7L, I don't know if it is rebuildable or not. NP 246GM transfer case is sold, RPO code GT4 3.73 gear ratio code
Burlington, ND
Multiple Prices
geno84
2023-10-20 06:50:35
2 Photos
Bbc flexplate
New never bolted on BBC flexplate, external balance.
Ray, ND
$50
Kash
2023-10-18 04:55:51
4 Photos
CV Axle, Sterring Knuckle, both for the passenger side. Transmission filter. Belt.
Everything is still brand new. I purchased them originally for my Ford Fusion SE 2011. (2.4L). would've put them
Mesa, AZ
Make an Offer
Les
2023-10-18 00:04:24
FOR SALE Left side exhaust manifold from a 1982 Ford 351w motor
Mandan, ND
$50
02 Chevy
2023-10-17 22:10:44
auto tranny for 02 jeep
good used tranny came out of a 02 jeep grand cherokee 4x4
New England, ND
Make an Offer
606 Ads | Page 19 of 21 | Jump to Page: